Cross beams

This was an exciting day because for the first time, the boat was one piece.  Not just a pile of lumber.  Not just a bunch of stringers.  But one single solid piece that was even boat shaped.  More or less.

Earlier when we were making the pieces for the stringers we trimmed a bunch of edges off of 2x4s.  Now we got to use the table saw to make some really weird-shaped boards.



We cut an edge off here, and a corner here.  There was a beam on either side of the bottom, a beam on either side of the top (the one near the ground since the hull is being built upside down), and a porch beam  that supported the edge of each of the two porches, for a total of six beams that hold the boat together latitudinally.


We epoxied and screwed these beams into place, making the boat a single piece.  We were so stoked that we pretty much took a photo from every possible angle.


There is an additional bonus beam not pictured here that we totally forgot until later.  It is clearly indicated in the plans, has notches in the stringers and so on.  I just overlooked it when we were makin stuff.  It is the motorwell mount.  It goes across the raked end of the bow, uh stern.  We realized it was missing after we finished the beams and so notched the stringers and installed it.  So imagine that in the photo below.


And then Kai took a nap.



Related Posts by Categories

0 komentar:

Posting Komentar




Blog Archive

Diberdayakan oleh Blogger.